Select/Reset/Information Switch Test/Replacement
- Remove the driver's airbag assembly (see
DRIVER'S AIRBAG REPLACEMENT
).
- Disconnect the 6P connector (A) from the select/ reset/information switch (B).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Measure the resistance between the select/reset/ information switch 6P connector terminals No. 6 and No. 5 in each switch position according to the table.
RESISTANCE SPECIFICATION
| Position |
Resistance |
| ↑ |
About 33 Ω |
| SEL/RESET |
About 1,043 Ω |
| ↓ |
About 363 Ω |
- If the resistance is not as specified, remove the two screws, and replace the switch.
- If the switch is OK, but there is a problem with the switch function, check the steering switches harness and cable reel.