Intermediate Shaft Disassembly

Intermediate Shaft Disassembly

Special Tools Required

- Driver 07749-0010000
- Support base attachment 07LAF-SM40300
- Support base 07965-SD90100
- Attachment, 42 x 47 mm 07746-0010300
1. Remove the heat shield (A).






2. Remove the outer seal (A) and the external snap ring (B) from the intermediate shaft (C).






3. Press the intermediate shaft (A) out of the intermediate shaft bearing (B) using the support base attachment (C), support base (D) and a press. Be careful not to damage the bearing support ring (E) on the intermediate shaft during disassembly.






4. Remove the internal snap ring.






5. Press the intermediate shaft bearing (A) out of the bearing support (B) using the support base attachment (C), support base (D), driver (E), 42 x47 mm attachment (F), and a press.