Torque Converter Housing Intermediary Shaft Bearing Replacement

Torque Converter Housing Intermediary Shaft Bearing Replacement

Special Tools Required

- Adjustable bearing puller, 20-40 mm 07736-A01000B
- Weight, remover 07741-0010201
- Driver 07749-0010000
- Attachment, 52 x 55 mm 07746-0010400
1. Remove the intermediary shaft bearing from the torque converter housing using the adjustable bearing remover and the sliding hammer weight.






2. Install the ATF guide plate (A), then install the new bearing (B) in the housing.






3. Drive the bearing into the housing using the driver and the attachment (52 x 55 mm).