A/T Differential Carrier, Final Driven Gear, and Transfer Drive Gear Replacement

A/T Differential Carrier, Final Driven Gear, and Transfer Drive Gear Replacement

NOTE: Inspect and adjust the bearing preload whenever the carrier is replaced.

1. Remove the final driven gear (A) and transfer drive gear (B) from the differential carrier (C).
NOTE: The final driven gear bolts have left-hand threads.

2. Install the final driven gear on the differential carrier in the direction shown. The letter on the final driven gear must match the letter on the top of the countershaft. They are a matched set.

3. Install the bolts through the differential carrier to the transfer drive gear.

4. Tighten the bolts to the specified torque in a crisscross pattern.