Side Airbag Replacement

Side Airbag Replacement

Removal

1. Do the battery terminal disconnection procedure, Procedures then wait for 3 minutes before starting work.

2. Disconnect the side airbag harness 2P connector (A).






3. Remove the seat assembly Front Seat Removal/Installation and seat-back cover. Front Seat-Back Cover Replacement
NOTE: If you are replacing a deployed airbag, replace the reinforcing cloth rear hooks (A).






4. Remove the mounting nut (B) and the side airbag (C).

Installation

NOTE:

- If the side airbag lid is secured with tape, remove the tape.

- Do not open the lid on the side airbag cover.

- Use new mounting nuts tightened to the specified torque.

- Make sure that the seat-back cover is installed properly. Improper installation may prevent proper deployment.

- Be sure to install the harness wires so that they are not pinched or interfering with other parts.

1. Place the new side airbag on the seat-back frame (A). Torque the new side airbag mounting nut (B).

2. Install the seat-back cover in the reverse order of removal. Front Seat-Back Cover Replacement
NOTE: If you are replacing a deployed airbag, replace the reinforcing cloth rear hooks.

3. Install the seat assembly, Front Seat Removal/Installation then connect the side airbag harness 2P connector.

4. Move the front seat and the seat-back through their full ranges of movement, making sure the harness wires are not pinched or interfering with other parts.

5. Do the battery terminal reconnection procedure. Procedures

6. Connect the HDS, and clear the DTCs. Initial Inspection and Diagnostic Overview

7. After installing the side airbag, confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.