Poor Acceleration; Flares When Starting Off In D, D3, and R; Stall Speed High In D and D3

Poor acceleration; flares when starting off in D, D3, and R; stall speed high in D and D3

Diagnostic Procedure:

1. 1st accumulator defective

2. 1st clutch defective

Also check for:

- Check the 1st clutch pressure.
- Inspect the clutch piston, clutch piston check valve, and O-rings. Check the spring retainer for wear and damage. Inspect the clearance between the clutch end-plate and the top disc. If the clearance is out of tolerance, inspect the clutch discs and plates for wear and damage, and also inspect the clutch wave-plate height. If the discs and plates are worn or damaged, replace the discs and plates as a set. If the wave-plate height is out of tolerance, replace the wave-plate. If the discs and plates are OK, adjust the clearance with the clutch end-plate.