Passenger's Dashboard Undercover Removal/Installation

Passenger's Dashboard Undercover Removal/Installation

NOTE: Take care not to scratch the dashboard and its related parts.

1. Remove the Passenger's dashboard undercover (A).
-1 Gently pull down the rear edge to detach the clips.
-2 Disconnect the footwell light connector (B) and ambient light connector (C).
-3 Pull the undercover away to release the pins (D) from the holders (E).

2. Install the undercover in the reverse order of removal, and note these items:
- Replace any damaged clips.

- Push the clips into place securely.

- Make sure that each connector is plugged in properly.

- Make sure the pins of the undercover are installed securely to the holders.