Front Passenger's Power Seat Motor Test

Front Passenger's Power Seat Motor Test

1. Remove the front passenger's power seat. Front Seat Removal/Installation

2. Remove the power seat adjustment switch (B) Front Seat Disassembly/Reassembly and disconnect the 12P connector (A) from the switch.






3. At the power seat adjustment switch 12P connector, test the motor by applying battery power and ground to the terminals according to the table.

4. If the motor does not run or fails to run smoothly, check for an open in the front passenger's seat wire harness between the power seat adjustment switch and each motor. If the wire harness is OK, replace the appropriate motor. Front Seat Linkage Disassembly/Reassembly
NOTE: The slide and up-down motors are not available separately because of the part of seat linkage, refer to the seat linkage disassembly/reassembly. Front Seat Linkage Disassembly/Reassembly

Slide motor:





Recline motor:





Front up-down motor:





Rear up-down motor: