A-Pillar Corner Trim Replacement

A-Pillar Corner Trim Replacement

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Take care not to scratch the trim and body.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Open the front door.

2. Using a trim tool, detach the bottom clip of the A-pillar corner trim (A).






3. Gently slide the A-pillar corner trim (A) up along the A-pillar to release it from the clips.

4. Using a trim tool, remove the clips from the body.

5. If the clips are damaged or stress-whitened, replace them with new ones.






6. Install the clips (A) on the A-pillar corner trim (B).






7. Hold the A-pillar corner trim (A) up, and fit the clips into the holes in the body, then push on the trim until the clips snap into place securely.