Center Console Beverage Holder Replacement

Center Console Beverage Holder Replacement

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Take care not to scratch the console.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the center console. Center Console Removal/Installation

2. Remove the center console panel. Center Console Panel Removal/Installation

3. Remove the console beverage holder (A) and the passenger's console panel (B) as an assembly:
-1 Detach the console subharness connector (C).
Remove the screws (D) securing the console beverage holder to the A/T gear position indicator panel (E) and the console frame (F).
-3 Remove the screws (G) securing the passenger's console panel to the console frame.
Pull out the passenger's console panel to detach the clips (H).






4. Remove the screws, then remove the center console beverage holder (A).






5. If necessary, separate both rails (A) from the outer case (B), then remove the shutter (C).

6. Install the beverage holder in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.