Instrument Fascia Removal/Installation

Instrument Fascia Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Take care not to scratch the dashboard and its related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Tilt the steering column down, and telescope it out.

2. Remove these items.
- Driver's outer dashboard trim Driver's Outer Dashboard Trim Removal/Installation

- Driver's inner dashboard trim Driver's Inner Dashboard Trim Removal/Installation

3. Remove the instrument fascia (A).
-1 Gently pull out the bottom to release the clips
-2 Disconnect the select/reset switch connector (B).

4. Install the instrument fascia in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Make sure the connector is plugged in properly.

- Push the clips into place securely.