Driver's Inner Dashboard Trim Removal/Installation

Driver's Inner Dashboard Trim Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Take care not to scratch the dashboard and its related parts.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the driver's inner dashboard trim (A).
-1 Gently pull out along the edge beside the audio unit by hand to release the lower hooks (B) and the clip (C).
-2 Detach the upper clips (D).






2. Install the trim in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.

- Position the hooks first on installation, then move the clips into place.

- Push the clips and hooks into place securely.