Center Console Panel Removal/Installation

Center Console Panel Removal/Installation

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Take care not to scratch the console.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the center console. Center Console Removal/Installation

2. Remove the center console latch panel. Center Console Latch Panel Removal/Installation

3. Pull the center console panel (A) out to detach the clips (B, C). Disconnect the accessory power socket connector (D) and seat heater switch connectors (E), detach the harness clip (F), then remove the panel.

4. Install the panel in the reverse order of removal, and note these items:
- Make sure each connector is plugged in properly.

- If the clips are damaged or stress-whitened, replace them with new ones.

- Push the clips into place securely.