Power Tailgate Motor Test (With Power Tailgate)

Power Tailgate Motor Test

1. Open the tailgate and remove the left rear pillar trim. Interior Trim Removal/Installation - Quarter Pillar Trim

2. Disconnect the 2P connector (A) from the power tailgate motor (B).

3. Close the tailgate manually.

4. Check the motor operation by connecting battery power to the terminal No. 1 and ground to the terminal No. 2. The motor should run (tailgate open).
NOTE: Be careful not to pinch your hands.

5. After opening the tailgate, connect battery power to the terminal No. 2 and ground the terminal No. 1. The motor should run (tailgate closed).

6. If the motor does not run or fails to run smoothly, replace the drive unit assembly. Service and Repair