Fuel Door Release Actuator: Testing and Inspection

Fuel Fill Door Opener Solenoid Test

NOTE: Before testing, check the B-CAN System Diagnosis Test Mode A. Troubleshooting - B-CAN System Diagnosis Test Mode A

1. Open the tailgate, and remove the left side trim panel. Interior Trim Removal/Installation - Cargo Area

2. Disconnect the 2P connector (A) from the fuel fill door opener solenoid (B).

3. Check solenoid operation by connecting power to the terminal No. 1 and ground to the terminal No. 2. To prevent damage to the solenoid, apply battery voltage only momentarily. The solenoid should work.

4. If the solenoid does not work as specified, replace it.