Rear Bumper Skid Trim Replacement

Rear Bumper Skid Trim Replacement

Special Tools Required

- KTC trim tool set SOJATP2014*
*Available through the Acura Tool and Equipment Program.

NOTE:

- Put on gloves to protect your hands.

- Take care not to scratch the front bumper.

- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Remove the rear bumper. Rear Bumper Removal/Installation

2. Remove all of the bolts (A) and screws (B). Pry all of the hooks (C) up with a trim tool, then remove the rear bumper skid trim (D) from the rear bumper (E).

3. Install the trim in the reverse order of removal, and push the hooks into place securely.