Symptom Troubleshooting

Symptom Troubleshooting: Audio disc skips

Special tools required

- Diagnostics CD 07AAZ-SDBA100
- Skip test CD 07AAZ-SDBA200
- Skip test CD 07AAZ-SDBA300

Audio disc skips

NOTE:

- Check the connectors for poor connections or loose terminals.

- Check the vehicle battery condition first.

1. Turn the ignition switch to ON (II).

2. Confirm the vehicle's tires are properly inflated.

3. Check the client's disc for scratches and fingerprints.
NOTE: The following test should be done with the audio unit bass and treble set to the client's listening settings. When comparing to known-good vehicles, do the comparison on the same model and trim level.

4. Test-drive the vehicle to identify when the client's disc skips. The audio diagnostic CD (T/N 07AAZ-SDBA100) can be used if the client's disc is not available; use tracks 10-12.

Does the disc skip?
YES - Go to step 5.

NO - Operation is normal.


5. Compare the client's skipping disc that skips to a known-good vehicle under the same conditions.

Does the disc skip in the known-good vehicle under the same conditions?
YES - The CD player operation is normal, the problem is with the client's disc.

NO - Go to step 6.
NOTE: Do the following test with vehicle parked and the engine running.


6. Insert the diagnostic skip test CD (T/N 07AAZ-SDBA300). Play tracks 2-11, and note on which number track(s) the disc starts skipping. Do the same test on a known-good vehicle.

Does the disc skip on same track(s) as the known-good vehicle?
YES - Operation is normal.

NO - Go to step 7.


7. Insert the diagnostic skip test CD (T/N 07AAZ-SDBA200). Play tracks 7-11 and tracks 13-15, and note on which number track(s) where the disc starts skipping. Do the same test on a known-good vehicle.

Does the disc skip on same track number(s) as the known-good vehicle?
YES - Operation is normal.

NO - Replace the audio unit. Audio Unit Removal/Installation