Speaker Test/Replacement

Speaker Test/Replacement

Door Speaker

1. Remove the door panel.
- Front: Front Door Panel Removal/Installation

- Rear: Rear Door Panel Removal/Installation

2. Remove the three mounting screws from the speaker (A).

3. Disconnect the 2P connector (B), and remove the speaker.

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 2 Ohms.

5. If the resistance is not as specified, replace the door speaker.






Center Speaker

NOTE:

- Put on gloves to protect your hands.

- Take care not scratch the dashboard.

1. Remove the center upper panel. Dashboard Center Upper Panel Removal/Installation

2. Remove the screws and the speaker (A).

3. Measure the resistance between terminals No. 1 and No. 2 there should be about 4 Ohms.

4. If the resistance is not as specified, replace the front center speaker.






Tweeter

1. Carefully pry the tweeter grille (A) out of the dashboard. Be careful not to damage the tweeter grille and the dashboard.

2. Disconnect the 2P connector (B) from the tweeter.






3. Remove the tweeter speaker from the speaker grille.

4. Check the capacitor (A) condition. If any problem is found, replace the tweeter.






5. Measure the resistance between the tweeter (A) terminal No. 2 and the outside terminal of the capacitor.
There should be about 6 Ohms.

6. If the resistance is not as specified, replace the tweeter.






Satellite Speaker

1. Remove the quarter pillar trim. Interior Trim Removal/Installation - Quarter Pillar Trim

2. Remove the speaker grille (A) and connector clip (B).

3. Remove the screws and the satellite speaker (C).

4. Measure the resistance between the terminals No. 1 and No. 2. There should be about 4 Ohms.

5. If the resistance is not as specified, replace the satellite speaker.






Subwoofer/amplifier unit (With navigation)

1. Remove the right rear side trim panel. Interior Trim Removal/Installation - Rear Side Area

2. Disconnect the 8P connector (A), then remove the bolts, nuts and pull out the subwoofer (B).






Input Test

1. With the connector still disconnected, make the input tests at the connector according to the table.





2. Reconnect the connector to the subwoofer/amplifier unit, and make the input test at the connector according to the table.





3. If the input test proves OK and the subwoofer has no sound, replace the faulty subwoofer/amplifier unit.

Subwoofer (Without navigation)

1. Remove the right rear side trim panel. Interior Trim Removal/Installation - Rear Side Area

2. Disconnect the 8P connector (A), then remove the bolts, nuts and pull out the subwoofer (B).

3. Measure the resistance between the terminals No. 2 and No. 7 and terminals No. 3 and No. 8. There should be about 2 Ohms.

4. If the resistance is not as specified, replace the subwoofer.