Symptom Troubleshooting

Symptom Troubleshooting: The MID displays and HFL message do not go away after pressing the HFL BACK button

The MID displays and HFL message do not go away after pressing the HFL BACK button

1. Connect the HDS to the DLC.

2. Clear the DTCs with the HDS.

3. Turn the ignition switch to LOCK (0), and then to ON (II).

4. Check for DTCs.

Are there any DTCs indicated?
YES - Repair the indicated DTCs.

NO - Go to step 5.


5. Turn the ignition switch to LOCK (0).

6. Substitute a known-good HandsFreeLink control unit, then turn the ignition switch to ON (II) and recheck the MID.

Are the messages cleared?
YES - Replace the original HandsFreeLink control unit.

NO - Replace the gauge control module. Service and Repair