LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2009 >> MDX V6-3.7L >> Repair and Diagnosis >> A L L Diagnostic Trouble Codes ( DTC ) >> Testing and Inspection >> Manufacturer Code Charts >> 42-1

42-1




SH-AWD DTC Troubleshooting: 42-1

DTC 42-1: Differential Fluid Temperature Sensor (Short to Power)

NOTE:

- Before you troubleshoot, review the general troubleshooting information. Initial Inspection and Diagnostic Overview

- If the vehicle was driven prior to this troubleshooting procedure, allow the rear differential to cool for more than an hour before continuing.

1. Turn the ignition switch to ON (II).

2. Make sure the HDS communicates with vehicle and the SH-AWD control unit. If it doesn't, troubleshoot the DLC circuit. Testing and Inspection

3. Clear the DTC with the HDS.

4. Check for DTCs with the HDS.

Is DTC 42-1 indicated?
YES - Go to step 5.

NO - Intermittent failure, the system is OK at this time.


5. Turn the ignition switch to LOCK (0).

6. Disconnect the rear differential fluid temperature sensor 2P connector and SH-AWD control unit connector A (20P).

7. Check for continuity between rear differential fluid temperature sensor 2P connector terminals No. 1 and No. 2.

Is there continuity?
YES - Repair short in the wire between rear differential fluid temperature sensor 2P connector terminals No. 1 and No. 2.

NO - Go to step 8.






8. Connect the rear differential fluid temperature sensor 2P connector.

9. Measure the differential housing temperature with an infrared temperature gauge near the mounting location of the rear differential fluid temperature sensor. The temperature should be below 176 °F (80 °C) before proceeding to the next step.

10. Measure resistance between SH-AWD control unit connector terminals A8 and A18.

Is there 260 Ohms or more?
YES - Update the SH-AWD control unit if it does not have the latest software, SH-AWD Control Unit Update or substitute a known-good SH-AWD control unit Service and Repair and recheck. If the symptom/indication goes away with the updated SH-AWD control unit, troubleshooting is complete. If the symptom/indication goes away with a known-good SH-AWD control unit, replace the original SH-AWD control unit. Service and Repair

NO - Replace the rear differential temperature sensor. Service and Repair