B1169

DTC Troubleshooting: B1168, B1169, B1178

DTC B1168: Gauge Control Module Lost Communication with PCM (ENG Message)

DTC B1169: Gauge Control Module Lost Communication with the PCM (A/T Message)

DTC B1178: F-CAN Communication Line Error

1. Clear the DTCs with the HDS.

2. Turn the ignition switch to LOCK (0) and then back ON (II).

3. Wait for more than 6 seconds.

4. Check for DTCs with the HDS.

Is DTC B1168, B1169, and/or B1178 indicated?
YES - Go to step 5.

NO - Intermittent failure, the system is OK at this time. Check for loose or poor connection between the gauge control module and the PCM.


5. Check for Fuel and Emissions Systems DTCs with the HDS.

Are there any DTCs indicated?
YES - Go to the indicated DTCs, then recheck.

NO - Go to step 6.


6. Turn the ignition switch to LOCK (0).

7. Disconnect gauge control module connector A (12P).

8. Jump the SCS line with the HDS.

9. Disconnect PCM connector A (49P).

10. Connect gauge control module connector A (12P) connector terminals No. 6 and No. 12 and body ground with jumper wires.






11. Check for continuity between body ground and PCM connector A (49P) terminals No. 48 and No. 49 individually.

Is there continuity?
YES - Update the PCM if it does not have the latest software PCM Update, or substitute a known-good PCM Initial Inspection and Diagnostic Overview, and recheck. If the indication goes away, replace the original PCM. Service and Repair If the DTC is still present, replace the gauge control module. Service and Repair

NO - Repair open in the wire.