Driver's Dashboard Lower Cover Removal/Installation

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through Honda Canada Inc. Technical Tools Department; Fax # 1-866-398-8665/e-mail: ch_technicaltools@ch.honda.com

NOTE:

Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Take care not to scratch the dashboard and related parts.

Adjust the steering column upward.
Gently pull out on the lower edge of the dashboard lower cover (A) to detach the lower clips.

Fig 1: Identifying Dashboard Lower Cover And Lower Clips
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Detach the upper clips, and release the hook (A) and pin (B) by pulling the driver's dashboard lower cover (C) back.

Fig 2: Identifying Driver's Dashboard Lower Cover And Hook
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the lower cover in the reverse order of removal, and note these items:
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.