LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2008 >> TSX Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Turn Signal/Hazard Warning Lights >> Hazard Warning Switch Test/Replacement >> '04-05 models

'04-05 models

  1. Remove the hazard warning switch (A).
    Fig 1: Identifying Hazard Warning Switch 5P Connector Terminals
    G05492885Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Disconnect the 5P connector (B) from the hazard warning switch.
  3. Remove the two mounting screws, then push out the hazard warning switch from behind the center panel.
  4. Check for continuity between the terminals in each switch position.
    Fig 2: Checking For Continuity Between Terminals In Each Switch Position
    G05492886Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. If the continuity is not as specified, replace the bulb (C) or the hazard warning switch.
scientia non olet · About LEMON Manuals