LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2008 >> TL Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Head >> Cylinder Head Cover Removal

Cylinder Head Cover Removal

  1. Remove the intake manifold (see REMOVAL ).
  2. Remove the six ignition coils (see IGNITION COIL REMOVAL/INSTALLATION ).
  3. Remove the three bolts (A) securing the harness holder, and remove the dipstick (B).
    Fig 1: Identifying Cylinder Head Cover Bolts
    G05457653Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Remove the bolt (A) securing the power steering (P/S) hose bracket.
    Fig 2: Identifying Power Steering (P/S) Hose Bracket Bolt
    G05457654Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the two bolts (B) securing the harness holder.
  6. Disconnect the breather hose (C).
  7. Remove the cylinder head covers.

    FRONT: 

    Fig 3: Identifying Cylinder Head Covers Bolts - Front
    G05457655Courtesy of AMERICAN HONDA MOTOR CO., INC.

    REAR: 

    Fig 4: Identifying Cylinder Head Covers Bolts - Rear
    G05457656Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals