A/T Clutch Pressure Control Solenoid Valve C Replacement

A/T Clutch Pressure Control Solenoid Valve C Replacement
1. Make sure you have the anti-theft codes for the audio system and the navigation system (equipped).
2. Disconnect the negative terminal from the battery, then disconnect the positive terminal.
3. Remove the battery hold-down bracket, and remove the battery cover, battery, and battery tray.
4. Remove the under-hood subfuse box from its bracket, and remove the bracket from the battery base.
5. Remove the intake air duct and air cleaner housing.
6. Remove the battery base and battery base bracket.
7. Disconnect the A/T clutch pressure control solenoid valve C connector.





8. Remove A/T clutch pressure control solenoid valve C.
9. Remove the ATF joint pipes, O-rings, ATF pipe, and gasket.
10. Clean the mounting surface and the fluid passage of the solenoid valve body and transmission housing.
11. Install the 8 x 53 mm ATF joint pipe (A) with the filter end into its mounting hole (B).





12. Check the height (A) of the 8 x 53 mm ATF joint pipe (B) between the top (C) of the pipe and solenoid valve body mounting surface (D). the height is about 7 mm (0.3 in.) If the height is over 7 mm (0.3 in.), push the pipe until it bottoms in the accumulator body.





13. Install the new gasket (A) on the transmission, housing, and install the 8 x 34.5 mm ATF joint pipe (B) with the filter end into the transmission housing and 8 x 25.2 mm ATF pipe (D).





14. Install the new O-rings (E) over the ATF joint pipes.
15. Install A/T clutch pressure control solenoid valve C.
16. Check the connector for rust, dirt, or oil, then connect it securely.
17. Install the battery base bracket and battery base.
18. Install the air cleaner housing and intake air duct.
19. Install the under-hood subfuse box on the battery base, and install the subfuse box on its bracket.
20. Install the battery tray, battery, battery cover, and battery hold-down bracket, then connect battery terminals.
21. Enter the anti-theft codes for the audio system and the navigation system (equipped). Set the clock (on vehicles without navigation).
22. Do the steering column position memorization.
23. Do the power window control unit reset procedure.