Safing Sensor: Service and Repair

Rear Safing Sensor Replacement

Removal

1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Disconnect both side curtain airbag 2P connectors.
3. Remove the second row seat.
4. Disconnect the floor wire harness 4P connector (A) from the rear safing sensor.






5. Remove the TORX bolt (B) using a TORX T30 bit, then remove the rear safing sensor (C).

Installation

1. Install the new rear safing sensor with the TORX bolt (A) then connect the floor wire harness 4P connector (B) to the rear safing sensor (C).






2. Reconnect the negative cable to the battery.
3. After installing the rear safing sensor, confirm proper system operation: Turn the ignition switch ON (II): the SRS indicator should come on for about 6 seconds and then go off.
4. Install all removed parts.