Brake Pedal Position Switch Test

Brake Pedal Position Switch Test

1. Disconnect the 4P connector (A) from the brake pedal position switch (B).






2. Check for continuity between the No. 1 and No. 2 terminals.
- There should be continuity when the brake pedal is pressed.
- There should be no continuity when the brake pedal is released.

3. Check for continuity between the No. 3 and No. 4 terminals.
- There should be no continuity when the brake pedal is pressed.
- There should be continuity when the brake pedal is released.

4. If necessary, adjust the pedal height, or replace the switch.