Checking the Front Passenger's Weight Sensors After A Vehicle Collision

Checking Front Passenger's Weight Sensors After a Vehicle Collision

1. Position the front passenger's seat to the rearmost position, adjust the seat-back to the forwardmost position. Do not move it from this position.
2. Drive the vehicle, accelerate to 20 mph (36 km/h), then stop on level ground.
3. Make sure the ignition switch is OFF.
4. Connect the HDS to the data link connector (DLC) (A).






5. Turn the ignition switch ON (II).
6. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit.
7. From the SRS inspection menu, select Seat Weight Sensor, then Misc test, then "SEAT OUTPUT CHK" and follow the prompts until the front passenger's weight sensor operation check is completed.