Driver's Dashboard Lower Cover Removal/Installation

Driver's Dashboard Lower Cover Removal/Installation

Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program.

NOTE:
- Take care not to scratch the dashboard and its related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Adjust the steering column upward.
2. Remove these items:
- Driver's outer dashboard trim
- Driver's inner dashboard trim

3. Remove the driver's dashboard lower cover (A).
1. Remove the screw (B).
2. Pull out the bottom of the driver's dashboard lower cover to release the clips (C).
3. Disconnect the humidity/in-car temperature sensor connector (D) and the air hose (E).






4. Install the cover in the reverse order of removal, and note these items:
- Make sure the humidity/in-car temperature sensor connector is plugged in properly, and the air hose is connected properly.
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.