LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> TSX Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Gauges >> Gauge Control Module Replacement

Gauge Control Module Replacement

NOTE: Before replacing the gauge control module, (see REWRITING THE ODO DATA AND TRANSFERING THE MAINTENANCE MINDER ON A NEW GAUGE CONTROL MODULE ).
  1. Remove the driver's dashboard lower cover (see DRIVER'S DASHBOARD LOWER COVER REMOVAL/INSTALLATION ), then remove the upper column cover (see STEERING COLUMN REMOVAL AND INSTALLATION ).
  2. Place a clean shop towel (A) under the gauge control module to prevent scratching the steering column or dash panel.
    Fig 1: Identifying Shop Towel
    G05492963Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the screws from the gauge control module (B).
  4. Disconnect the 22P and 18P connectors (C), then remove the gauge control module.
  5. Install the gauge control module in the reverse order of removal.
scientia non olet · About LEMON Manuals