LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> TSX Automatic >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> Fuel Supply System >> Fuel Pump/Fuel Gauge Sending Unit Replacement

Fuel Pump/Fuel Gauge Sending Unit Replacement

  1. Remove the fuel tank unit (see FUEL TANK UNIT REMOVAL AND INSTALLATION  ).
  2. Remove the fuel filter set (A).
    Fig 1: Identifying Fuel Filter Set
    G05490813Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the fuel gauge sending unit (B), the case (C), the wire harness (D), and the fuel pressure regulator (E).
  4. When connecting the fuel pump assembly, make sure the connection is secure and the suction filter (F) is firmly connected to the fuel pump (G).
  5. Check these items before installing the fuel tank unit:
    • When connecting the wire harness, make sure the connection is secure and the connectors (H) are firmly locked into place.
    • When installing the fuel gauge sending unit, make sure the connection is secure and the connector is firmly locked into place. Be careful not to bend or twist it excessively.
  6. Install the parts in the reverse order of removal with new O-rings (I). When installing the fuel tank unit, align the marks on the unit and the fuel tank (see INSTALLATION  ).
scientia non olet · About LEMON Manuals