LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> TL Base >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Gauges >> Select/Reset/Information Switch Test/Replacement

Select/Reset/Information Switch Test/Replacement

  1. Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
  2. Disconnect the 20P connector (A) from the cable reel.
    Fig 1: Identifying 20P Connector
    G05462801Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminal in each switch position according to the table.
    Fig 2: Continuity Specifications Chart
    G05462802Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the continuity is not as specified, replace the switch.
scientia non olet · About LEMON Manuals