DTC B1170: Gauge Control Module Lost Communication with VSA Modulator-Control Unit (VSA Message)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Check for the DTCs in the PCM and the VSA with the HDS.
Are any DTCs indicated?
YES -Troubleshoot the indicated PCM or VSA DTCs.
NO -Go to step 4.
- Turn the ignition switch OFF, and then back ON (II).
- Check for DTCs with the HDS.
Is DTC B1170 indicated?
YES -Do the gauge control module input test (see GAUGE CONTROL MODULE INPUT TEST ).
NO -Intermittent failure, the F-CAN communication line is OK at this time. Check for loose or poor connections. If the connections are good, check the battery condition (see BATTERY TEST ), and the charging system.