DTC B1157: Gauge Control Module Lost Communication with Multiplex Integrated Control Unit (MICU)
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see
TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch OFF, and then back ON (II).
- Check for DTCs with the HDS.
Is DTC B1157 indicated?
YES -Go to step 4.
NO -Intermittent failure. The gauge control system is OK at this time. Check pin fits and connections.
- Check for DTCs with the HDS.
Are DTCs B1055, B1255 and B1806, B1556 also indicated?
YES -Go to Multiplex Integrated Control Unit Input Test (see MICU INPUT TEST ).
NO -Go to Gauge Control Module Input Test (see GAUGE CONTROL MODULE INPUT TEST ).