LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2007 >> RL >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Gauges >> Select/Reset/Information Switch Test/Replacement

Select/Reset/Information Switch Test/Replacement

  1. Remove the driver's airbag assembly (see DRIVER'S AIRBAG REPLACEMENT ).
  2. Disconnect the 6P connector (A) from the select/ reset/information switch (B).
    Fig 1: Identifying Select/ Reset/Information Switch And 6P Connector
    G05497145Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Measure resistance between the select/reset/ information switch 6P connector No. 6 and No. 5 terminals in each switch position according to the table.
    TERMINALS RESISTANCE CHART

    Position Resistance
    ↑ About 33 Ω
    SEL/RESET About 1,043 Ω
    ↓ About 363 Ω
  4. If the resistance is not as specified, remove the two screws and replace the switch.
  5. If the switch is OK, but there is a problem with the switch function, check the steering switches harness and cable reel.
scientia non olet · About LEMON Manuals