Center Console Beverage Holder
Center Console Beverage Holder ReplacementSpecial Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE:
- Take care not to scratch the console.
- Use the appropriate tool from the KTC trim toll set to avoid damage when removing components.
1. Remove the center console.
2. Remove the console panel.
3. Remove the console beverage holder (A) and passenger's console panel (B) as an assembly:
1. Detach the console subharness connector (C).
2. Remove the screws (D) securing the console beverage holder to the A/T gear position indicator panel (E) and console frame (F).
3. Remove the screws (G) securing the passenger's console panel to the console frame.
4. Pull out the passenger's console panel to detach the clips (H).
4. Remove the screws, then remove the center console beverage holder (A).
5. If necessary, separate both rails (A) from the outer case (B), then remove the shutter.
6. Install the beverage holder in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.