VSA (Vehicle Stability Assist)
DTC 61: IG1 Voltage Low1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle at 2 mph (3 km/h) or more.
4. Check for DTCs with the HDS.
Is DTC 61 indicated?
YES-Go to step 5.
NO-Intermittent failure, the system is OK at this time. Check for loose terminals at the VSA modulator-control unit 46P connector. Check for a loose connection at G303. Refer to intermittent failures troubleshooting.
5. Test the battery and connections.
Are the battery and battery connections OK?
YES-Check for a poor connection at the battery terminals, and all IG1 circuit connections between the VSA modulator-control unit 46P connector terminal No. 40 and the under-dash fuse/relay box No. 29 (10A) fuse. If the connections are good, go to the Alternator and Regulator Circuit Troubleshooting.
NO-Replace or charge the battery, or repair the connections.