VSA (Vehicle Stability Assist)

DTC 22: Current Flow into Wheel Sensor Input Amplifier

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF, then turn it ON (II) again.
4. Check for DTCs with the HDS.

Is DTC 22 indicated?

YES-Do the DTC 11, 13, 15, and/or 17 troubleshooting.

NO-intermittent failure, the system is OK at this time. Check for loose terminals between the wheel sensor 2P connector and the VSA modulator control unit 46P connector. Check for a loose connection at G303. Refer to intermittent failures troubleshooting.