Passenger's Dashboard Undercover Removal/Installation

NOTE: Take care not to scratch the dashboard and related parts.

Remove the passenger's dashboard undercover (A).
1. Gently pull out the rear edge to detach the clips (B, C).
2. Pull the undercover away to release the pins (D) from the holders (E).
3. For some models: If equipped with a foot light illumination, disconnect the foot light illumination connector (F).
  
  Fig 1: Identifying Foot Light Illumination Connector, Clips And Pins
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the undercover in the reverse order of removal, and note these items.
- Make sure the foot light illumination connector is plugged in properly (for some models).
- Check if the clips are damaged or stress-whitened, and if necessary, replace them with new ones.
- Push the clips into place securely.