LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2006 >> TSX Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Exterior Lights >> Taillight Replacement >> Inner Taillight

Inner Taillight

  1. Open the trunk lid and disconnect the connectors (A) from the trunk lid.

    Taillight: 3 CP 

    Back-up Light: 21 W 

    Fig 1: Identifying Trunk Lid Connectors And Inner Taillight With Nuts
    G05492870Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the three nuts and the inner taillight (B).
  3. Turn the bulb socket 45° counterclockwise to remove the bulb.
  4. Inspect the gasket; replace it if it is distorted or stays compressed.
  5. Install the taillight and tighten the nuts to 5 N.m (0.5 kgf.m, 4 lbf.ft).
  6. After installing the taillight, run water over it to make sure it does not leak.
scientia non olet · About LEMON Manuals