LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2006 >> MDX Base >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Cylinder Head >> Cylinder Head Cover Removal

Cylinder Head Cover Removal

  1. Remove the intake manifold (see REMOVAL ).
  2. Remove the six ignition coils (see IGNITION COIL REMOVAL/INSTALLATION ).
  3. Remove the dipstick.
  4. Remove the two bolts (A) securing the harness holder, and remove the positive crankcase ventilation (PCV) hose (B).
    Fig 1: Removing Harness Holder Bolts
    G03639351Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Disconnect the three injector connectors from the injectors on the cylinder head (see INJECTOR REPLACEMENT ).
  6. Remove the power steering hose bracket mounting bolt (A) and the harness holder mounting bolts (B).
    Fig 2: Removing Power Steering Hose Bracket Mounting Bolt
    G03639352Courtesy of AMERICAN HONDA MOTOR CO., INC.
  7. Remove the harness clamps (C) and breather hose (D).
  8. Remove the cylinder head cover.

    FRONT 

    Fig 3: Removing Cylinder Head Cover (Front)
    G03639353Courtesy of AMERICAN HONDA MOTOR CO., INC.

    REAR 

    Fig 4: Removing Cylinder Head Cover (Rear)
    G03639354Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals