Glove Box Striker Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. While holding the glove box, release the glove box stop on each side from the dashboard by pushing them inside (see step  1 on ).
2. Remove the screws, then remove the glove box striker (A).
   Fig 1: Identifying Glove Box Striker And Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the striker in the reverse order of removal.