Passenger's Vent

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

NOTE:

Take care not to scratch the dashboard and related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when prying components.
Put on gloves to protect your hands.

While holding the glove box (A), release the glove box stop (B) on each side from the dashboard by pushing them inside.

Fig 1: Identifying Glove Box And Glove Box Stop
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Push on the side hooks (A) by hand to release them. Gently pull out the side vent (B) to release the other hooks (C), then remove the passenger's vent.

Fig 2: Pushing Side Hooks, Hooks And Side Vent (Outer)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 3: Pushing Side Hooks, Hooks And Side Vent (Center)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the passenger's vents in the reverse order of removal.