OPDS/ODS Unit Initialization

When a seat-back cover, seat-back cushion, and/or OPDS/ODS unit is replaced, initialize the OPDS/ODS by doing this procedure.

1. Clear the DTC memory (see CLEAR THE DTC MEMORY WITH THE HDS  ).
2. Make sure the front passenger's seat is dry. Set the seat-back in a normal position, and make sure there is nothing on the seat.
3. Make sure the ignition switch is OFF and the MES connector is not shorted.
4. Connect the HDS to the data link connector (DLC) (A).
   Fig 1: Identifying Data Link Connector

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Turn the ignition switch ON (II).
6. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit:
   • '04-06 models (see DLC CIRCUIT TROUBLESHOOTING )
   • '07-08 models (see '07-08 MODELS )
7. From the HDS Main Menu, select SRS, then SRS, then Calibration. In the Calibration Menu, select ODS INIT. Follow the screen prompts to initialize the OPDS/ODS unit.
8. Turn the ignition switch OFF.
9. Disconnect the HDS from the DLC.
   NOTE: If the OPDS/ODS fails to initialize after several attempts, replace the OPDS sensor/seat-back and retry. If the OPDS/ODS continues to fail to initialize, replace the OPDS/ODS unit (see OPDS/ODS UNIT REPLACEMENT  ).