LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> SRS (Supplemental Restraint System) >> General Troubleshooting Information >> Reading the DTC

Reading the DTC

  1. Make sure the ignition switch is OFF.
  2. Connect the HDS to the data link connector (DLC) (A).
    Fig 1: Identifying Data Link Connector
    G05489537Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Turn the ignition switch ON (II).
  4. Make sure the HDS communicates with the vehicle and the SRS unit. If it does not communicate, troubleshoot the DLC circuit:
  5. Use the HDS to check for DTCs.
  6. Read and record the DTC.
  7. Turn the ignition switch OFF, then wait for 10 seconds.
  8. Disconnect the HDS from the DLC.
  9. Do the troubleshooting procedure for the DTC.
scientia non olet · About LEMON Manuals