DTC 81-71,81-78: ODS Unit Does Not Calibrate ('06-08 models)
NOTE:
Before doing this troubleshooting procedure, review SRS Precautions and Procedures (see PRECAUTIONS AND PROCEDURES
) and General Troubleshooting Information (see DTC (DIAGNOSTIC TROUBLE CODES)
).
- Clear the DTC memory (see CLEAR THE DTC MEMORY WITH THE HDS ).
- Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
Does the SRS indicator stay on, and is DTC 81-71, or 81-78 indicated?
YES -Go to step 3.
NO -Intermittent failure, system is OK at this time. Go to TROUBLESHOOTING INTERMITTENT FAILURES . If another DTC is indicated, troubleshoot the DTC.
- Calibrate the ODS unit (see ODS UNIT CALIBRATION ).
- Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds, and then goes off.
Does the SRS indicator go off?
YES -The system is OK.
NO -Go to step 5.
- Replace the ODS unit (see OPDS/ODS UNIT REPLACEMENT ).
- Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds, and then goes off.
Does the SRS indicator go off?
YES -The system is OK.
NO -Replace the SRS unit (see SRS UNIT REPLACEMENT ).