LEMON Manuals: Even more car manuals for everyone
Home >> Acura >> 2005 >> TSX Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission Clutch) >> Clutch Replacement >> Flywheel Replacement

Flywheel Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Install the ring gear holder (A).
    Fig 1: Identifying Ring Gear Holder
    G05490930Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Remove the flywheel mounting bolts in a crisscross pattern in several steps, then remove the flywheel and ring gear holder.
  3. Install the flywheel on the crankshaft, and install the mounting bolts finger-tight.
  4. Install the ring gear holder (A), then torque the flywheel mounting bolts (B) in a crisscross pattern in several steps.
    Fig 2: Ring Gear Holder And Flywheel Mounting Bolts w/Torque Specification
    G05490931Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals