Transmission Fluid Inspection and Replacement

WARNING: This page is about a different variant/trim than selected.

Raise the vehicle on a lift.
Remove the splash shield (see step 26 ).
Remove the filler plug (A) and washer (B), check the condition of the fluid, and make sure it is at the proper level (C).

Fig 1: Identifying Filler Plug, Washer And Fluid Proper Level
If the fluid is dirty, remove the drain plug (A), and drain it.

Fig 2: Drain Plug w/Torque Specs.
Install the drain plug with a new washer, and refill the transmission fluid to the proper level.
Fluid Capacity

2.0 L (2.1 US qt) at fluid change

2.2 L (2.3 US qt) at overhaul

Always use Acura Manual Transmission Fluid (MTF). Using engine oil can cause suffer shifting because it does not contain the proper additives.
Install the filler plug (B) with a new washer.
Install the splash shield (see step 25 ).