Crankshaft Pulley Removal and Installation: Installation

Clean the crankshaft pulley (A), crankshaft (B), bolt (C), and washer (D). Lubricate new engine oil as shown.

Fig 1: Identifying Cleaning And Lubricating Points
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the crankshaft pulley, and hold the pulley with holder handle (A) and holder attachment (B).

Fig 2: Identifying Holder Handle And Holder Attachment
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Tighten the bolt to 50 N.m (5.0 kgf.m, 37 lbf.ft) with a torque wrench and 19 mm socket (C). Do not use an impact wrench.
Mark the bolt head (A) and the crankshaft pulley (B) as shown, then tighten the bolt an additional 90° (The mark on the bolt head line up with the mark on the crankshaft pulley).

Fig 3: Tightening Crankshaft Pulley An Additional 90°
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the drive belt (see DRIVE BELT REPLACEMENT ).
Install the splash shield (see step 25 on TRANSMISSION INSTALLATION ).
Install the front wheels.