Chain Case Oil Seal Installation

Special Tools Required 

• Handle driver 07749-0010000
• Attachment, 52 x 55 mm 07746-0010400

1. Use the handle driver and attachment to drive a new oil seal squarely into the chain case to the specified installed height.
   Fig 1: Driving Oil Seal Into Chain Case

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Measure the distance between the chain case surface (A) and oil seal (B).

   Oil Seal Installed Height: 

   33.0-33.7 mm (1.30-1.33 in.) 

   Fig 2: Measuring Distance Between Chain Case Surface And Oil Seal

   Courtesy of AMERICAN HONDA MOTOR CO., INC.